How to repair the pressure bearing of electric vehicle?

1. Spray the rust remover on the screws to be disassembled to facilitate disassembly, saving time and effort without damaging the wires.

2. If the front wire and brake wire may be inconvenient to disassemble, unplug the connector to avoid forcible disassembly and easy disconnection and cause trouble.

3. Do not tighten the screws with force. When you encounter difficult screws, screw them "back and forth", otherwise the front fork screw pattern will be easily damaged.

4. It is wrong to just change the steel ball without changing the bowl, and the wear of the bowl cannot be ignored. Some because of the trouble-free (bowl) not changing, the unevenness of the (bowl) will cause the steel ball to run hard and easy to break.

Tip: Prepare a slender steel bar, tap the bottom bowl from top to bottom, and tap the top bowl from bottom to top, and it will come down easily.

5. Don't hit hard with a hammer when serving the "bowl".

Tip: Use a small square wood to hold the bowl in place evenly.

6. Apply lubricating oil. The friction of the lubricating steel ball without lubricating oil will increase and it will not be durable. The upper and lower steel balls will let the oil be sufficient.

7. The upper cover wire should be moderate, not too loose and too tight, and it is better not to block it. The upper fixing wire must be tightened to avoid loosening of the wire, causing the handlebar to move, and the front fork does not move.

8. Arrange the wires and fix them with wire harnesses so as not to hinder the steering.